Unified MSDS Summary — Rubber & Plastics Chemicals
Applies to rubber additives, tyre additives, textile & plastic-rubber additives, and rubber raw materials · Document ref: GBL-MSDS-RC · Effective 2026-10-18
This is a unified safety summary for the rubber and plastics chemical families listed on the platform.
The exact composition and hazard classification of each substance are confirmed in the product-specific Safety Data Sheet (SDS / MSDS)
supplied with every batch. Handle all such materials as industrial chemicals and follow the precautions below unless the
product-specific SDS states otherwise.
1. Identification
| Product types covered | Rubber accelerators, anti-scorch agents, antioxidants, vulcanising agents, fillers (e.g. carbon black), plasticisers, resins, masterbatches |
|---|
| Typical form | Powder, granule, pellet, flake, or liquid concentrate |
|---|
| Intended use | Industrial raw material for rubber / plastics compounding and manufacturing |
|---|
| Not for | Food, pharmaceutical, or consumer direct contact unless explicitly certified |
|---|
2. Hazard Identification (general)
| General | May cause mild skin / eye irritation on contact. Dust may irritate respiratory tract. Some items are combustible powders — avoid ignition sources. |
|---|
| Specific | Refer to the per-substance SDS for GHS classification (e.g. oxidizing, harmful, or sensitising items). |
|---|
3. Composition
| Principal constituents | As declared on the product page and per-batch COA. Typical assay ≥ 97% for accelerator grades. |
|---|
| Impurities | Within industry-standard limits; confirmed per batch. |
|---|
4. First Aid
| Skin | Remove contaminated clothing; wash with soap and water. |
|---|
| Eyes | Rinse thoroughly with clean water for ≥15 minutes; seek medical advice if irritation persists. |
|---|
| Inhalation | Move to fresh air; if breathing is difficult, seek medical attention. |
|---|
| Ingestion | Do not induce vomiting; rinse mouth and seek medical attention. |
|---|
5. Handling & Storage
| Handling | Use in well-ventilated area; avoid dust generation; keep away from heat, sparks, open flame. |
|---|
| Storage | Dry, cool, well-ventilated store; keep container closed; separate from incompatible materials. |
|---|
| Shelf life | Typically 12 months under proper storage; confirm per product. |
|---|
6. Personal Protection
| PPE | Dust mask / respirator, safety goggles, gloves, protective clothing as appropriate. |
|---|
7. Fire Fighting & Spill
| Extinguishing | Dry powder, foam, or carbon dioxide; water spray to cool surroundings. |
|---|
| Spill | Sweep / vacuum (avoid dry sweeping of dust where possible); dispose per local regulation. |
|---|
8. Transport
| General | Per applicable ADR / IMDG / IATA rules for the specific substance; many items are not classified as dangerous goods in finished packaged form — confirm with the per-batch SDS and carrier. |
|---|
Regulatory note: Substances requiring EU REACH registration (including certain rubber masterbatches) are, until
registration is completed, supplied to non-EU markets only. EU-market supply is offered only where registration / the
relevant authorisation is in place.
Disclaimer: This unified summary is for general guidance and does not replace the product-specific SDS / MSDS, which is supplied with
each batch and takes precedence. Always read the per-batch SDS before use. GlobalB2B is the export trading platform; manufacturing is
performed by the designated supplier shown on each product page.